Our Manufacturing Process
Engine Blocks:
US Engine Production only uses blocks that pass our strict quality inspection process. First, all engine
blocks are degreased, and cleaned in special industrial washers before being Magna-Fluxed to check for
cracks. Every cylinder is bored to within .004 of the finished size. Next, we use a diamond hone to ensure
bore geometry is held within 200 millionths of an inch. Every block is subject to a surface finish test to
measure the roughness and plateau finish of the cylinder wall. (With today's lightweight motor oils and
low-tension oil rings, this is critical for achieving the proper ring seal.) Blocks are checked and align
honed through the main bearing bores, to the proper factory specifications. This is critical to maintain
uniform oil clearances and good oil pressure. Once all machine work is finished on the block,
it is thoroughly cleaned until it is completely grit free. We scrub each cylinder with soap and water,
and clean all oil galleys with a high-pressure wash.
Cylinder Heads:
First, heads are totally disassembled, washed and Magna-Fluxed to check
for cracks. After head castings are machined to ensure flatness, the valve seats are cut on the latest state
of the art equipment, forming all three angles at once. This ensures the correct seat width and connectivity
for good valve seal and heat transfer. The head is then assembled to factory tolerances using high temperature
valve stem seals, valve springs, and hardened valve locks. Each valve/spring combination is individually tested
to provide the correct spring pressure, and vacuum tested to ensure a tight valve seal.
Crank/Cam Shafts:
Crankshafts and Camshafts are reground to the factory tolerances. The
Crankshaft and Camshafts are both micro-polished to exceed the original finish, ensuring proper bearing
lubrication. A final wash is done to ensure that every crank is clean. After the camshaft's lobes have been
reground to the same specifications as the original cam, it is then Parkerized to protect the surfaces from
corrosion and wear.
- Bake cleaned and then shot blasted
- Checked for bend
- Ground to size
- Oil holes chamfered
- Journals polished
- All camshafts that do not meet original specifications are replaced with new or remanufactured camshafts.
Rods:
Like every other component of our remanufactured engines, the rods are as close to
perfect as possible. This helps us in building the most reliable remanufactured engine on the road today.
- Every rod installed in our engines goes through a rigorous restoration process.
- Rods Are Chemically cleaned
- 100% re-manufactured - bores are machined to original tolerances for size and surface finish
- Checked for bend and twist - any rod that doesn't meet our exacting tolerance is discarded
- All bushings are 100% replaced
Engine Assembly:
US Engine Production assembles each engine in a clean and controlled
environment under the supervision of our highly trained Quality Control department. Constant supervision,
testing, and cross-department auditing ensures every Engine gets the same attention to careful assembly
and results in consistent superior quality.
Testing and Final Inspection:
Following assembly of the engine it is put through a vigorous
load-bearing run on the DYNO/SIM TEST Machine for over one hour to test its excellence, after which it heads
over to our lead technician for a final inspection and approval for release to the customer.
Guarantee:
In addition, to guarantee the satisfaction of our clients, we provide a
one year Unlimited Mileage parts/or replacement only warranty on all of our engines.